tinyUSB/hw/bsp/ch32v20x/boards/nanoch32v203/board.h

/* metadata:
   name: nanoCH32V203
   url: https://github.com/wuxx/nanoCH32V203
*/

#ifndef BOARD_H_
#define BOARD_H_

#ifdef __cplusplus
extern "C" {
#endif

#define LED_PORT       GPIOA
#define LED_PIN        GPIO_Pin_15
#define LED_STATE_ON   0
#define LED_CLOCK_EN() RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE)
#define LED_MODE       GPIO_Mode_Out_OD

#define UART_DEV        USART1
#define UART_CLOCK_EN() RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1, ENABLE)
#define UART_TX_PIN     GPIO_Pin_9
#define UART_RX_PIN     GPIO_Pin_10

#ifdef __cplusplus
}
#endif

#endif
embed metadata to family.c and board.h to generate supported boards doc 2024-12-27 09:11:09 +07:00			`/* metadata:`
			`name: nanoCH32V203`
			`url: https://github.com/wuxx/nanoCH32V203`
			`*/`

add CH32V20x USB OTG/FS driver 2023-11-19 18:26:40 -08:00			`#ifndef BOARD_H_`
			`#define BOARD_H_`

			`#ifdef __cplusplus`
			`extern "C" {`
			`#endif`

			`#define LED_PORT GPIOA`
			`#define LED_PIN GPIO_Pin_15`
			`#define LED_STATE_ON 0`
Allow different port and mode for LED on ch32v boards While there is a define for the port, the clock enable is hardcoded for GPIOA, so setting a different port than GPIOA doesn't work. This fixes it by adding a define for enabling the port clock. It also adds a define for the pin mode, because not all boards have the LED connected in a way that open drain works with it. 2025-03-07 12:20:33 +01:00			`#define LED_CLOCK_EN() RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE)`
			`#define LED_MODE GPIO_Mode_Out_OD`
add new ch32v203g6u board, sysfreq is defined in board.cmake/mk 2024-06-21 16:08:37 +07:00
			`#define UART_DEV USART1`
			`#define UART_CLOCK_EN() RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1, ENABLE)`
			`#define UART_TX_PIN GPIO_Pin_9`
			`#define UART_RX_PIN GPIO_Pin_10`
add CH32V20x USB OTG/FS driver 2023-11-19 18:26:40 -08:00
			`#ifdef __cplusplus`
			`}`
			`#endif`

			`#endif`