- add esp32 c3, c6 mcu option

- skip breakpoint for espressif riscv

src/common/tusb_mcu.h

@@ -429,8 +429,8 @@
 #define TUP_MCU_MULTIPLE_CORE 0
 #endif
 
-#if !defined(TUP_DCD_ENDPOINT_MAX)
-  #warning "TUP_DCD_ENDPOINT_MAX is not defined for this MCU, default to 8"
+#if !defined(TUP_DCD_ENDPOINT_MAX) && defined(CFG_TUD_ENABLED) && CFG_TUD_ENABLED
+#warning "TUP_DCD_ENDPOINT_MAX is not defined for this MCU, default to 8"
   #define TUP_DCD_ENDPOINT_MAX    8
 #endif
 

src/common/tusb_verify.h

@@ -84,7 +84,7 @@
     if ( (*ARM_CM_DHCSR) & 1UL ) __asm("BKPT #0\n"); /* Only halt mcu if debugger is attached */            \
   } while(0)
 
-#elif defined(__riscv)
+#elif defined(__riscv) && !TUP_MCU_ESPRESSIF
   #define TU_BREAKPOINT() do { __asm("ebreak\n"); } while(0)
 
 #elif defined(_mips)

src/portable/analog/max3421/hcd_max3421.c

@@ -479,6 +479,8 @@ bool hcd_init(uint8_t rhport) {
   _hcd_data.spi_mutex = osal_mutex_create(&_hcd_data.spi_mutexdef);
 #endif
 
+  // NOTE: driver does not seem to work without nRST pin signal
+
   // full duplex, interrupt negative edge
   reg_write(rhport, PINCTL_ADDR, _tuh_cfg.pinctl | PINCTL_FDUPSPI, false);
 

src/tusb_option.h

@@ -120,6 +120,8 @@
 #define OPT_MCU_ESP32S2           900 ///< Espressif ESP32-S2
 #define OPT_MCU_ESP32S3           901 ///< Espressif ESP32-S3
 #define OPT_MCU_ESP32             902 ///< Espressif ESP32 (for host max3421e)
+#define OPT_MCU_ESP32C3           903 ///< Espressif ESP32-C3
+#define OPT_MCU_ESP32C6           904 ///< Espressif ESP32-C6
 #define TUP_MCU_ESPRESSIF         (CFG_TUSB_MCU >= 900 && CFG_TUSB_MCU < 1000) // check if Espressif MCU
 
 // Dialog