more example update

examples/device/uac2_headset/src/main.c

@@ -102,7 +102,8 @@ int main(void)
 {
   board_init();
 
-  tusb_init();
+  // init device stack on configured roothub port
+  tud_init(BOARD_TUD_RHPORT);
 
   TU_LOG1("Headset running\r\n");
 

examples/device/uac2_headset/src/tusb_config.h

@@ -31,30 +31,45 @@
 extern "C" {
 #endif
 
-//--------------------------------------------------------------------
-// COMMON CONFIGURATION
-//--------------------------------------------------------------------
-
 #include "usb_descriptors.h"
 
+//--------------------------------------------------------------------+
+// Board Specific Configuration
+//--------------------------------------------------------------------+
+
+// RHPort number used for device can be defined by board.mk, default to port 0
+#ifndef BOARD_TUD_RHPORT
+#define BOARD_TUD_RHPORT      0
+#endif
+
+// RHPort max operational speed can defined by board.mk
+#ifndef BOARD_TUD_MAX_SPEED
+#define BOARD_TUD_MAX_SPEED   OPT_MODE_DEFAULT_SPEED
+#endif
+
+//--------------------------------------------------------------------
+// Common Configuration
+//--------------------------------------------------------------------
+
 // defined by compiler flags for flexibility
 #ifndef CFG_TUSB_MCU
 #error CFG_TUSB_MCU must be defined
 #endif
 
-#define CFG_TUSB_RHPORT0_MODE       OPT_MODE_DEVICE
-
 #ifndef CFG_TUSB_OS
-#define CFG_TUSB_OS                 OPT_OS_NONE
+#define CFG_TUSB_OS           OPT_OS_NONE
 #endif
 
 #ifndef CFG_TUSB_DEBUG
-// Can be set during compilation i.e.: make LOG=<value for CFG_TUSB_DEBUG> BOARD=<bsp>
-// Keep in mind that enabling logs when data is streaming can disrupt data flow.
-// It can be very helpful though when audio unit requests are tested/debugged.
-#define CFG_TUSB_DEBUG              0
+#define CFG_TUSB_DEBUG        0
 #endif
 
+// Enable Device stack
+#define CFG_TUD_ENABLED       1
+
+// Default is max speed that hardware controller could support with on-chip PHY
+#define CFG_TUD_MAX_SPEED     BOARD_TUD_MAX_SPEED
+
 /* USB DMA on some MCUs can only access a specific SRAM region with restriction on alignment.
  * Tinyusb use follows macros to declare transferring memory so that they can be put
  * into those specific section.
@@ -67,7 +82,7 @@ extern "C" {
 #endif
 
 #ifndef CFG_TUSB_MEM_ALIGN
-#define CFG_TUSB_MEM_ALIGN          __attribute__ ((aligned(4)))
+#define CFG_TUSB_MEM_ALIGN        __attribute__ ((aligned(4)))
 #endif
 
 //--------------------------------------------------------------------