枚举失败

examples/device/cdc_dual_ports/src/tusb_config.h

@@ -35,9 +35,9 @@
 //--------------------------------------------------------------------+
 
 // RHPort number used for device can be defined by board.mk, default to port 0
-#ifndef BOARD_TUD_RHPORT
-#define BOARD_TUD_RHPORT      0
-#endif
+// #ifndef BOARD_TUD_RHPORT
+// #define BOARD_TUD_RHPORT      0
+// #endif
 
 // RHPort max operational speed can defined by board.mk
 #ifndef BOARD_TUD_MAX_SPEED
@@ -49,23 +49,43 @@
 //--------------------------------------------------------------------
 
 // defined by board.mk
+#define CFG_TUSB_MCU    OPT_MCU_STM32F4
 #ifndef CFG_TUSB_MCU
 #error CFG_TUSB_MCU must be defined
 #endif
 
 #ifndef CFG_TUSB_OS
-#define CFG_TUSB_OS           OPT_OS_NONE
+#define CFG_TUSB_OS           OPT_OS_RTTHREAD
 #endif
 
 #ifndef CFG_TUSB_DEBUG
-#define CFG_TUSB_DEBUG        0
+#define CFG_TUSB_DEBUG        3
 #endif
+#ifdef CFG_TUSB_DEBUG
+#define CFG_TUSB_DEBUG_PRINTF rt_kprintf
+#endif /* CFG_TUSB_DEBUG */
 
 // Enable Device stack
 #define CFG_TUD_ENABLED       1
 
+  // fs is 0; hs is 1
+  #ifndef BOARD_DEVICE_RHPORT_NUM
+    #define BOARD_DEVICE_RHPORT_NUM 1
+  #endif
+
 // Default is max speed that hardware controller could support with on-chip PHY
-#define CFG_TUD_MAX_SPEED     BOARD_TUD_MAX_SPEED
+
+  #ifndef BOARD_DEVICE_RHPORT_SPEED
+    #define BOARD_DEVICE_RHPORT_SPEED OPT_MODE_FULL_SPEED
+  #endif
+
+  #if BOARD_DEVICE_RHPORT_NUM == 0
+    #define CFG_TUSB_RHPORT0_MODE (OPT_MODE_DEVICE | BOARD_DEVICE_RHPORT_SPEED)
+  #elif BOARD_DEVICE_RHPORT_NUM == 1
+    #define CFG_TUSB_RHPORT1_MODE (OPT_MODE_DEVICE | BOARD_DEVICE_RHPORT_SPEED)
+  #else
+    #error "Incorrect RHPort configuration"
+  #endif
 
 /* USB DMA on some MCUs can only access a specific SRAM region with restriction on alignment.
  * Tinyusb use follows macros to declare transferring memory so that they can be put