moving irq to bsp for lpc17/40

hw/bsp/mbed1768/board.mk

@@ -17,9 +17,6 @@ MCU_DIR = hw/mcu/nxp/lpcopen/lpc175x_6x/lpc_chip_175x_6x
 # All source paths should be relative to the top level.
 LD_FILE = hw/bsp/mbed1768/lpc1768.ld
 
-# TODO remove later
-SRC_C += src/portable/$(VENDOR)/$(CHIP_FAMILY)/hal_$(CHIP_FAMILY).c
-
 SRC_C += \
 	$(MCU_DIR)/../gcc/cr_startup_lpc175x_6x.c \
 	$(MCU_DIR)/src/chip_17xx_40xx.c \
@@ -44,5 +41,7 @@ FREERTOS_PORT = ARM_CM3
 JLINK_DEVICE = LPC1768
 JLINK_IF = swd
 
-# flash using jlink
-flash: flash-jlink
+# flash using pyocd 
+flash: $(BUILD)/$(BOARD)-firmware.hex
+	pyocd flash -t lpc1768 $<
+

hw/bsp/mbed1768/mbed1768.c

@@ -135,6 +135,20 @@ void board_init(void)
 #endif
 }
 
+//--------------------------------------------------------------------+
+// USB Interrupt Handler
+//--------------------------------------------------------------------+
+void USB_IRQHandler(void)
+{
+  #if CFG_TUSB_RHPORT0_MODE & OPT_MODE_HOST
+    tuh_isr(0);
+  #endif
+
+  #if CFG_TUSB_RHPORT0_MODE & OPT_MODE_DEVICE
+    tud_isr(0);
+  #endif
+}
+
 //--------------------------------------------------------------------+
 // Board porting API
 //--------------------------------------------------------------------+