Fix handling of interrupt endpoints. i.e. no ZLPs.
Fix the assignation of endpoint types.
Add button support for MM900evx boards.
On board support do not block for UART input.
Correct USB FIFO use for setup data phases (OUT transfers). We cannot stop traffic on the control endpoint so we set a flag and pull data from host when tinyUSB requests it from the USB FIFO. Extend this for all endpoints although currently not required.
Rename all instances of ft90x which can apply to ft93x as ft9xx.
Add support for the cdc_dual_ports example for ft9xx.
Add LED pin definition for board LED in a simple to access place on the Bridgetek MM900EVx boards.
The SetLineCoding would fail as host would send the SETUP OUT phase before tinyUSB had setup a transaction for it. ft9xx port would ignore the transfer since there was no valid transaction setup for it. One SETUP data phase packet is cached now.
IAR generates warning Pe111 'statement is unreachable'. In a couple of
cases, replace return statements with TU_ATTR_FALLTHROUGH; because some
compilers apparently can't figure out that the return statements are
unreachable but do whinge about an imagined fall-through without them!
ISO packet size is up to 1023 for full speed device.
Upon completion of ISO reception, reported length of incoming packet
was truncated to one byte only.
This results in incorrect data stream for higher bit rates
48 samples * 4 bytes per sample * 2 channels = 384 bytes of data
and 128 was reported.
There is no change in logic extending xact_len to uint16_t fixes the issue.
Some compilers don't support the GNU extension `typeof` so their definitions
of `hw_set_alias` can't inherit their type from their argument, and the best
we can do is have `hw_set_alias` act the same as `hw_set_alias_untyped`.
This requires an explicit cast when the macro is used instead, otherwise
IAR generates error Pe132 'expression must have pointer-to-struct-or-union
type but it has type "void *"'.
The same goes for `hw_clear_alias`.
Field started (regardind transfer) was only cleaed when transfer
was finished.
For audio devices set interface is called many times.
When there is no audio (silence) set interface requests zero
lenght bandwithd that in turn calls dcd_edpt_close().
When endpoint is closed due to set interface request transfer
should not longer be started since it will block next start transfer
with assert.
This just sets 'started' to false when endpoint is closed.
